Cabin maintenanceToyota Voxy ZRR80

Toyota Voxy ZRR80: Replace the Cabin Air Filter (2014 Manual)

Toyota's documented 2014 petrol Voxy ZRR80 glove-box and cabin-filter replacement steps, with the 20,000 km / 10,000 km dusty-use interval and UP-marking precaution.

Time
10–20 minutes
Difficulty
Easy
Tools
2 needed
Instructions
7 steps

Applies to Toyota Voxy ZRR80 · 2014 Japan-market petrol Voxy ZRR80 manual edition (not hybrid ZWR80). Toyota Voxy petrol ZRR80 generation with matching January 2014 Japan-market glove-box, HVAC and original filter equipment; not the ZWR80 hybrid. Always compare the described parts, labels and specifications with your own vehicle and manual.

What you’ll need

  • Cabin filter sized for the 2014 ZRR80 vehicle and fitted HVAC equipment
  • Toyota Voxy January 2014 owner's manual, printed pages 253–255

Step-by-step instructions

Follow these steps

Follow the written instructions in order; illustrations are optional, not a requirement for a complete guide. If a component or label looks different on your car, stop and check your own manual.

  1. Step 1 of 7

    Confirm this is the petrol ZRR80 and match its filter housing

    Check that the Voxy is from the original petrol ZRR80 configuration covered by Toyota's January 2014 manual, not the hybrid ZWR80 or later generations. Toyota recommends changing this filter at 20,000 km under standard conditions, or 10,000 km in areas with heavy traffic, dust or cold conditions.

  2. Step 2 of 7

    Switch the engine off and open the glove box

    Park securely and set the ignition switch to LOCK or OFF as equipped. Empty and lower the glove box gently, identifying the attached damper stay on the side rather than pulling straight against it.

  3. Step 3 of 7

    Release the damper pin and glove-box stops

    Disconnect the damper-stay pin shown in the Toyota manual. Press the glove-box side walls inward to release each upper stopper one at a time, and release the lower tabs as shown to remove the box without forcing the plastic engagements.

  4. Step 4 of 7

    Unlock and slide out the filter case cover

    Find the air-conditioning filter housing behind the glove box. Release the cover's lock, then slide the cover in the direction Toyota shows to disengage the hooks. Do not pry or pull it while its retaining tab is still engaged.

  5. Step 5 of 7

    Remove the old element and follow the correct UP marking

    Slide the used cabin-filter element out and install the proper new replacement. In Toyota's January 2014 manual, the UP mark is oriented upward. An aftermarket AIR FLOW arrow can represent airflow rather than UP orientation, so consult that filter's own instructions if the markings differ.

  6. Step 6 of 7

    Refit the cover, glove box and damper in reverse order

    Secure the filter cover and its lock, then engage the glove box's lower and upper fittings and reconnect the damper stay. Make sure the box opens and closes normally, without loose clips or unusual resistance.

  7. Step 7 of 7

    Check cabin airflow without operating the HVAC filterless

    With the replacement filter and cover installed, test normal ventilation airflow. Toyota says not to run the air conditioner without its filter, and not to wash or blow-clean the disposable replacement-type element. Seek service if the housing design differs or poor airflow persists.

References & limitations

Where these instructions come from

Toyota Voxy petrol ZRR80 generation with matching January 2014 Japan-market glove-box, HVAC and original filter equipment; not the ZWR80 hybrid

Toyota describes the exact release sequence and 20,000/10,000 km reference interval. Neither filter fitment across later years nor interchangeability with other Toyota models is assumed.

Toyota Voxy petrol owner manual, January 2014 Japan edition ↗

Manual section: Printed pp. 253–256, section 6-2 'Air-conditioning filter replacement' (エアコンフィルターの交換): glove-box damper, side and bottom tabs, sliding cover, UP orientation, replacement interval and fragile-tab warning

Instructions checked against manufacturer documentation; not a physical inspection of every vehicle.