Tyres & wheelsToyota Voxy ZRR80

Toyota Voxy ZRR80: Check Cold Tyre Pressure on 15- or 16-Inch Wheels

By CarFactBook · Review source evidence and limitations

Toyota's original 2014 Voxy manual lists 240 kPa cold pressure at both axles for the standard 195/65R15 and 205/60R16 packages. This guide covers correct tyre identification, four-wheel gauge readings and leak checks.

Time
10–15 minutes
Difficulty
Easy
Tools
3 needed
Instructions
7 steps

Applies to Toyota Voxy ZRR80 · 2014–2021. 2014-generation Toyota Voxy ZRR80 with original documented tyre sizes; tyre pressure label and matching exact grade take priority.. Always compare the described parts, labels and specifications with your own vehicle and manual.

Manual-referencedToyota OEM owner manualToyota Voxy 2014 manual printed p. 249–251 (tyre inspection and original-pressure chart) and p. 350 (maintenance specifications); both 195/65R15 91S and 205/60R16 92H shown at 240 kPa front/rear.
Review evidence and limitations ↓

Tools and materials

  • Reliable tyre-pressure gauge
  • Air compressor or pump capable of regulated adjustments
  • Driver-side Toyota factory pressure label

Step-by-step instructions

Follow these steps

Follow the written instructions in order; illustrations are optional, not a requirement for a complete guide. If a component or label looks different on your car, stop and check your own manual.

  1. Step 1 of 7

    Identify the exact tyre size on the ZRR80

    Look at tyre sidewalls for the factory 195/65R15 91S or 205/60R16 92H specification. Check the driver-side pressure label and do not assume aftermarket fitments use the same figures.

    Check before moving on

    Tyres and grade match Toyota's factory 2014 chart.

    All steps ↑
  2. Step 2 of 7

    Confirm 240 kPa is appropriate for all four road wheels

    Toyota's 2014 manual lists 240 kPa (2.4 kgf/cm²) cold pressure for the documented road-tyre packages at both front and rear. Confirm with the actual car's pressure label. The emergency spare, where fitted, is listed separately at 420 kPa.

    Check before moving on

    The correct NORMAL road-tyre target is recorded as 240 kPa front/rear.

    All steps ↑
  3. Step 3 of 7

    Allow tyres to be cold before reading

    Check before a journey or after enough cooling for accurate cold values. Park safely away from moving traffic and remove the valve cap on one wheel.

    Check before moving on

    Tyre is cool and a pressure gauge is ready.

    All steps ↑
  4. Step 4 of 7

    Measure front left, front right, rear left and rear right

    Press the gauge securely against each valve and note each reading. If air hisses continuously, reposition the gauge rather than assuming the result is correct.

    Check before moving on

    Four trustworthy readings recorded.

    All steps ↑
  5. Step 5 of 7

    Inflate or release air in small increments

    Adjust each normal tyre to the verified factory cold pressure, then take a second reading. Never use the sidewall's maximum inflation pressure or the emergency-spare setting as your normal road target.

    Check before moving on

    All road wheels match confirmed factory label.

    All steps ↑
  6. Step 6 of 7

    Inspect tread, cuts and abnormal wear

    Toyota's manual asks owners to check cracked rubber, visible damage, groove depth and unusual wear along with pressure. Refit all valve caps and seek qualified inspection if any defect is found.

    Check before moving on

    No dangerous visible defect; valve caps secured.

    All steps ↑
  7. Step 7 of 7

    Log the readings and check again periodically

    Record date, four cold values, tyre sizes and vehicle grade. Check periodically and before travel with heavy loads, using the actual manufacturer's label if any fitted part changes.

    Check before moving on

    A date-stamped record of four pressures is available.

    All steps ↑

References & limitations

Where these instructions come from

2014-generation Toyota Voxy ZRR80 with original documented tyre sizes; tyre pressure label and matching exact grade take priority.

The factory 240/240 kPa applies to the manual's specified original 195/65R15 and 205/60R16 packages. Emergency spare pressure is different (420 kPa); do not use the spare tyre number on road wheels.

Toyota OEM owner manual ↗

Manual section: Toyota Voxy 2014 manual printed p. 249–251 (tyre inspection and original-pressure chart) and p. 350 (maintenance specifications); both 195/65R15 91S and 205/60R16 92H shown at 240 kPa front/rear.

Instructions checked against manufacturer documentation; not a physical inspection of every vehicle.